SodaStream Quick Disconnect Adaptor for FreedomOne Hose / Screw In Bottles

Stop spending money on expensive refills! If you've purchased a new SodaStream machine you'll notice all of your old bottles won't fit. Frustrating I know, now you have to go and buy more expensive canisters. OR you could purchase this adaptor with one of our FreedomOne hose adaptors and hook up a 2.6kg or 6kg Tank and not worry about frequent refill costs.

Please note : This is commonly used only for FreedomOne Hose adaption. If you use it to adapt bottles, the bottle will protrude out the bottom of the machine as it makes it slightly longer. 

A typical Soda Stream cylinder can only carbonate up to 60L and will cost about $20 per fill. So given these figures the larger cylinder and this hose will pay itself off once you fill the 2.6kg gas cylinder once. It's a no brainer! 

We have included two options when drilling through your bench top to fit your hose. Either remove the stainless thread from the brass connection and drill a 14-15mm hole. You will need to use Lock-Tite glue or plumbers tape to get a good seal on this connection after you re-fit it. Without removing the brass connection piece you would need to drill a 30mm hole to fit the bottle connection end through your bench top.

Additional Recommended Purchase:

• CYLC-CCO2-C 2.6kg CO2 Cylinder (Full)
• CYLD-CCO2-D 6.0kg CO2 Cylinder (Full)
• KL04190 36 Inch FreedomOne Hose Adaptor
• KL04206 72 Inch FreedomOne Hose Adaptor

Dimensions:

• 37mm Length
• 19mm Inner thread
• 20mm Inlet Adapter